Dodge SRT Viper Forums : ViperAlley banner
1 - 7 of 7 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
I was quoted around $800 in labor to install a set of T&D Rockers with new push rods, is this price typical on a Gen II?
 

·
Registered
Joined
·
723 Posts
I would say run away fast. it will be a 4-5 hr job, even at $100/hr it wouldn't cost that much. I just had mine installed with push rods in about 4 hrs.
 

·
Registered
Joined
·
3,494 Posts
ok...to far for me to drive. The price is to high. There are plenty of people in Kali that can help you out and if you have some decent mechanical skills, the install is not bad.
 

·
Registered
Joined
·
723 Posts
I don't think you can tell, mid-range seems better. It seems like it runs a bit rich after the install. I will tune it on the dyno with the vec1 on dyno day april 24th.
 
1 - 7 of 7 Posts
Top