Dodge SRT Viper Forums : ViperAlley banner
1 - 3 of 3 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
It seems like the gen4 factory side sill heat shield is far superior from what my gen2 had from the factory. Should the gen 4 heat shielding be upgraded or just left alone. Not having any notable heat sink issues, but the gen 4 heat shield tends to get a small tingy vibration, just off idle...
recently upgraded to full belanger with high flow cats btw
 

·
Registered
Joined
·
34 Posts
I have the same setup, with the OEM heat shielding, just make sure the adhesive is stickied to the inside of the side sill. Works just fine, the sill gets warm to the touch but that's about the extent of it.
 

·
Registered
Joined
·
4,155 Posts
I'll take "Header/Exhaust Wrap" for $800 Alex.
 
  • Like
Reactions: Rob5
1 - 3 of 3 Posts
Top