Dodge SRT Viper Forums : ViperAlley banner
1 - 5 of 5 Posts

·
Registered
Joined
·
3,847 Posts
Check the stand height according to the directions. Then determine what shim to use.
 

·
Registered
Joined
·
858 Posts
Simms:

the instructions force you to pull the heads to measure. It is not needed, Jerome is correct, the adjustable push rod is a simple way to measure the required push rod length. The next step is using the shims to get the correct pattern on the valve. The key to success is getting the adjuster to operate as close as possible to one full turn down (.050) from full up.

Mike has installed a bunch he is a good source.
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top