DynoJet question

1181 Views 10 Replies 8 Participants Last post by Simms, Dec 10, 2003

Simms

Discussion Starter · Dec 9, 2003

Hoping Dave Weaver or some of you dynno wizards can help me here.

There is a dyno right up the road from me and I want to get a stock baseline on my car before I do any mods. The guy told me it was $84 for two passes. Is that enough to establish a good baseline, and how does that price compare?

He also said a little "bung" would have to be welded into my exhaust to read the a/f. Is he full of shit on that one?

Save

1 - 1 of 11 Posts

Jack B

· #8 · Dec 10, 2003

Simms:

have him put his wideband into the forward factory well. I have close to 100 pulls using the oem well. My car is a 97, some of the newer cars may show "Service Engine Code", but, not the 96-98. The tailpipe probe is not accurate especially with cats.

Save

1 - 1 of 11 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month