Dodge SRT Viper Forums : ViperAlley banner
1 - 6 of 6 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
We have a problem with our car, we don't get any engine parameters on the display. when we read it with OBD then we have an connection.

Somewhere in the manual i've found that before you make a readout with OBD you should remover the cim.
The first time we didn't done that, now I think that the problem is in the cim.

Or is it just a lose contact somewhere?
 

·
Registered
Joined
·
3 Posts
Discussion Starter · #4 ·
We bought the car last year, and made none chances to the car.
But we run with a ADL3 dash and a upgraded stock ecu. So none off the stock wiring has chanced.
 

·
Registered
Joined
·
4 Posts
If you upgraded from an ADL1 or 2 to an ADL3 the pinouts change a bit in the back of the display so that might be your issue.

Call PRS (Precision Racing Services..... p-r-s.com) and ask for Dave Decker. They built the original comp coupe harnesses so he has all the pinout diagrams. You will most likely have to move some pins on the harness side of the connector.

If you can't do the pinout changes we can help.
 

·
Premium Member
Joined
·
9,913 Posts
Advertising not allowed in sig unless you are a supporting vendor. Pm sent
 
1 - 6 of 6 Posts
Top