Went to install a new crank in the viper and when the tolerances were checked one lobe measured from .001 to .0015 with plastic gage. This indicates there is a slight taper? Should I be concerned? All the other measurements were .0015
Crank flatness question
1 - 3 of 3 Posts
.0005 is a lot of taper in that short of a distance, but I'm not sure I'd trust plasti-gage for an accurate measurement.
I would have it checked by a reputable machine shop. Plasti-gage can be fairly accurate but .0005 is quite a tight measurement.
Hey at this point, why wouldn't you have it look at?
Hey at this point, why wouldn't you have it look at?
1 - 3 of 3 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Dodge SRT Viper Forums : ViperAlley
A forum community dedicated to Dodge SRT Viper owners and enthusiasts. Come join the discussion about performance, modifications, classifieds, troubleshooting, maintenance, and more!
Full Forum Listing
Top Contributors this Month
View All
plumcrazy
208 Replies
Brickhead
174 Replies
Whitebeard
168 Replies
Join now to ask and comment!
