Dodge SRT Viper Forums : ViperAlley banner
1 - 2 of 2 Posts

·
Registered
Joined
·
33 Posts
Discussion Starter · #1 ·
I am not getting any codes when I plug in the OBD2.
The red brake light remains on - as if the parking brake is not released.
I'm sure it is something simple, but where should I begin, please?
 

·
Registered
Joined
·
33 Posts
Discussion Starter · #3 ·
Assuming you’ve verified the parking brake switch is released, check your master cylinder level.


Sent from my iPad using Tapatalk
Thanks Widow Maker, I had not thought about the brake light switch.
I guess I have to remove the cover around the shifter and parking brake lever, and also remove the small storage tray between the seats? is that correct?
The Master Cylinder is up to level.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top