Dodge SRT Viper Forums : ViperAlley banner
1 - 1 of 1 Posts

· Premium Member
Joined
·
1,255 Posts
You can route them through the rubber grommets where all the other wires
inter the back- but that would require removing more panels than my first
suggestion - which is -
Put the car on stands and route the wires out of a hole drilled in the
bottom front of the trunk - then they can be either pulled through the shifter-boot - or you can drill a hole in the sheet metal right below the fog light
switch - and pull the wires through. You'll have to get under your car to pull
the wires through the drive shaft tunnel, but it's easy - and quick.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top