Dodge SRT Viper Forums : ViperAlley banner
1 - 1 of 1 Posts

· Registered
Joined
·
4,296 Posts
Discussion Starter · #1 ·
Hi,

i have a 00 RT/10. Im installing a new head and amp for my ride. In the process i'm also replacing the signal cables with new ones. My question is, where do you route the cables through? My thinking is to take the signal cables through the rear firewall (bulkhead?) and drill a hole through it and run the cables all the way up front through the center console. What do you think -is this the best way of routing the signal cables?

Thanks in advance!
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top