Dodge SRT Viper Forums : ViperAlley banner
1 - 2 of 2 Posts

·
Registered
Joined
·
4,814 Posts
Discussion Starter · #1 ·
Hi,

i have a 00 RT/10. Im installing a new head and amp for my ride. In the process i'm also replacing the signal cables with new ones. My question is, where do you route the cables through? My thinking is to take the signal cables through the rear firewall (bulkhead?) and drill a hole through it and run the cables all the way up front through the center console. What do you think -is this the best way of routing the signal cables?

Thanks in advance!
 

·
Premium Member
Joined
·
1,333 Posts
You can route them through the rubber grommets where all the other wires
inter the back- but that would require removing more panels than my first
suggestion - which is -
Put the car on stands and route the wires out of a hole drilled in the
bottom front of the trunk - then they can be either pulled through the shifter-boot - or you can drill a hole in the sheet metal right below the fog light
switch - and pull the wires through. You'll have to get under your car to pull
the wires through the drive shaft tunnel, but it's easy - and quick.
 
1 - 2 of 2 Posts
Top