if your issue was the tubing on the intercooler, why did you not say?
I have many cast aluminum elbows
Or if it is the fact you were sent the ntercooler that goes with the system you ordered and not the gen 3 system like you said on the phone, I have many many others that could have been shipped
This isn't this exact system
but it gives you an idea how the system attaches to the inter-cooler, but Allan, since you are just doing what the guys in Estonia tell you, you really don't know what you are asking for, correct?
And I know this is the intercooler that you want now, you could have just asked... I have a few just laying around
Or you could have upgraded to our twin front mount air to air setup that allows for air to get to the radiator as well, so it has the benefits of an air to air as well as no detriments that the air to water advocates claim...
if you didn;t like where the turbo hotsides showed some surface rust from being wiped down, you could have said so, you only said "It doesn't look like the picture"
the picture being the Gen 3 system i.e. picture of gen 3
here is my email response to your call on Feb 3rd
Dodge Viper SRT10 Twin Turbo System
The complete system pics are of the SRT10 system, not the Gen 2 system they were shipped so the items will look different.
If they want I can send the same or similar intercooler, but the headers are the same as the header in the header picture, and since the system they ordered is the Gen 2 system not the SRT system a lot of the items will look different.
But lets recap,
you received a Gen 2 turbo system shipped in less than 90 days
you received a free 3" V band connect cat back upgrade
you received a free 79 mm upgrade, when you emailed and said you guys needed more power
you received all new silicone and T bolts and Mandrel bends
You received Oil-less, billet wheel, water cooled, turbos for less than other charge for journal bearing oil using turbos
you didn't like a couple easily correctable bent tubes on an intercooler, but could not communicate this, if you had a new intercooler could have been sent
you didn't like a little surface rust on a cast iron piece that once you install it will be covered in surface rust and couldn't communicate that, we could have powder coated the hot sides for $120 each if you had asked for it... , Yes, I should have dried out the inside of the hot-sides better after I wiped them down before shipping, the outsides were fine...as we can see in the pics