Viper Alley - Dodge Viper Forum -SRT Viper - Search Results
 
Go Back   Viper Alley - Dodge Viper Forum -SRT Viper » Search Forums
» Live Feed « · War Room · Graffiti Wall · Arcade · Viper Blogs ·  

Showing results 1 to 25 of 167
Search took 0.21 seconds.
Search: Posts Made By: Turbokraft
Forum: Viper Discussions - Gen I & II June 6th, 2020, 04:57 PM
Replies: 12
Views: 542
Posted By Turbokraft
Your car is OBD1 and therefore not a 4 digit code...

Your car is OBD1 and therefore not a 4 digit code but a 2 digit. Code 12 retrieved by cycling the key means the battery was disconnected within the last 50 key cycles. As Dean stated code 55 is "end...
Forum: Viper Discussions - Gen I & II June 6th, 2020, 04:37 PM
Replies: 17
Views: 3,166
Posted By Turbokraft
DBW Toyota is a different animal, such things...

DBW Toyota is a different animal, such things will not happen to your Dodge DBC. Follow the good advice above regarding chemical choice, use a cloth rag if you are overly concerned about damage to...
Forum: Viper Discussions - Gen I & II May 27th, 2020, 06:30 AM
Replies: 8
Views: 244
Posted By Turbokraft
Need more Dave6666.....

Need more Dave6666.....
Forum: Viper Discussions - Gen I & II May 8th, 2020, 07:00 AM
Replies: 16
Views: 698
Posted By Turbokraft
1.8 has gotcha covered^^^

1.8 has gotcha covered^^^
Forum: Viper Discussions - Gen I & II May 7th, 2020, 07:02 AM
Replies: 16
Views: 698
Posted By Turbokraft
Did the beer virus get Dave6666? A woman of...

Did the beer virus get Dave6666? A woman of generous proportions smother him with too much love? Is he allergic to cats(1.8T)? Did he sell the Viper and now he is being banned from all the Mustang...
Forum: Viper Discussions - Gen I & II April 25th, 2020, 04:40 PM
Replies: 48
Views: 1,631
Posted By Turbokraft
He is not ok unless he posts a build thread about...

He is not ok unless he posts a build thread about said FrankenROE, with results, without fat chicks.
Forum: Viper Discussions - Gen I & II April 20th, 2020, 01:14 PM
Replies: 13
Views: 495
Posted By Turbokraft
Moroso spirals, who wrote an article about those?

Moroso spirals, who wrote an article about those?
Forum: Viper Discussions - Gen I & II April 20th, 2020, 08:01 AM
Replies: 48
Views: 1,631
Posted By Turbokraft
Many folks allow their anger and frustration to...

Many folks allow their anger and frustration to outpace their wisdom and say/type unpleasant things, not something I condone. AJO2, this is not a defense of Dave6666 as he is plenty smart enough to...
Forum: Viper Discussions - Gen I & II April 18th, 2020, 04:58 PM
Replies: 48
Views: 1,631
Posted By Turbokraft
I enjoyed his considerable input towards...

I enjoyed his considerable input towards technical resolutions for pattern failures of the Gen 2 platform. I try to avoid anything personal with any member and had friendly interaction with the...
Forum: Viper Discussions - Gen V SRT 2013-up March 27th, 2020, 07:20 AM
Replies: 6
Views: 683
Posted By Turbokraft
It would be a good idea to drive a Gen 2 if you...

It would be a good idea to drive a Gen 2 if you like your Vette. I have both (97 GTS, 08 Z06) and they are night and day different. A Viper is not for everyone, I love my Viper and truly enjoy it....
Forum: The Garage October 21st, 2019, 07:37 AM
Replies: 1
Views: 252
Posted By Turbokraft
I have had a small repair operation in the Fla....

I have had a small repair operation in the Fla. panhandle for over 23 years, I have yet to see anything positive about that company and two eye witness accounts of rebuilds that were garbage about 18...
Forum: Viper Discussions - Gen III & IV SRT October 14th, 2019, 07:11 AM
Replies: 2
Views: 245
Posted By Turbokraft
Contact Dan Lesser at Viper specialties.

Contact Dan Lesser at Viper specialties.
Forum: Viper Discussions - Gen I & II February 9th, 2019, 06:27 PM
Replies: 9
Views: 682
Posted By Turbokraft
Thank you for the vid, enjoyed the history.

Thank you for the vid, enjoyed the history.
Forum: Viper Discussions - Gen I & II October 24th, 2018, 06:28 AM
Replies: 18
Views: 872
Posted By Turbokraft
I have spec clutch and light flywheel (steel)....

I have spec clutch and light flywheel (steel). For an aftermarket setup it works pretty well but does chatter sometimes (rarely). I have a very steep driveway that requires some extra revs to climb...
Forum: Viper Discussions - Gen III & IV SRT July 27th, 2018, 07:25 AM
Replies: 7
Views: 834
Posted By Turbokraft
^^^^that thing had better have "bribes" stored in...

^^^^that thing had better have "bribes" stored in every available crevice or you will have about 70000000000000000 penalty laps. Still a heck of an idea and no doubt much fun. Should be awarded many...
Forum: Viper Discussions - Gen III & IV SRT June 23rd, 2018, 01:55 PM
Replies: 65
Views: 6,123
Posted By Turbokraft
Shim the rockers to reduce pre-load from .060 to...

Shim the rockers to reduce pre-load from .060 to .025. Cranking speed=160-225 rpm virtually no oil pressure. Static cranking pressure may be much different than dynamic running pressure. Case in...
Forum: Viper Discussions - Gen III & IV SRT June 23rd, 2018, 08:43 AM
Replies: 65
Views: 6,123
Posted By Turbokraft
I believe the builder/Crower are implying that...

I believe the builder/Crower are implying that the valves are held off the seat when oil pressure expands the lifter and this would also produce the symptoms you have. Many aftermarket hi-po lifters...
Forum: Viper Discussions - Gen I & II June 19th, 2018, 07:11 AM
Replies: 12
Views: 1,304
Posted By Turbokraft
The wife is definitely a keeper, I hope the Viper...

The wife is definitely a keeper, I hope the Viper can keep up with her! Congrats on the ride and using it as Dodge intended.
Forum: Viper Discussions - Gen III & IV SRT June 9th, 2018, 08:30 AM
Replies: 9
Views: 790
Posted By Turbokraft
LOL, just read your second post, you have...

LOL, just read your second post, you have answered you own question,sort of.
Forum: Viper Discussions - Gen III & IV SRT June 9th, 2018, 08:28 AM
Replies: 9
Views: 790
Posted By Turbokraft
As above, low battery voltage contributes to this...

As above, low battery voltage contributes to this problem on all makes w/electronic throttle. There are several redundant sensors on both the throttle valve and accelerator pedal that must agree with...
Forum: Viper Discussions - Gen III & IV SRT June 9th, 2018, 08:21 AM
Replies: 65
Views: 6,123
Posted By Turbokraft
Manifold pressure is very low. I would...

Manifold pressure is very low. I would inspect/verify cam timing.
Forum: Viper Discussions - Gen III & IV SRT June 8th, 2018, 01:06 PM
Replies: 65
Views: 6,123
Posted By Turbokraft
in/hg works for me as I am unfamiliar with h20. ...

in/hg works for me as I am unfamiliar with h20. The reason for the question is as others have suggested I believe your cam is installed wrong. Poor idle, low power, Dieseling, fuel burning in...
Forum: Viper Discussions - Gen III & IV SRT June 8th, 2018, 07:22 AM
Replies: 65
Views: 6,123
Posted By Turbokraft
What is the intake manifold pressure at idle?...

What is the intake manifold pressure at idle? Part throttle cruise?
Forum: Viper Discussions - Gen I & II May 16th, 2018, 07:19 AM
Replies: 259
Views: 25,181
Posted By Turbokraft
Great that the car has rewarded your hard work...

Great that the car has rewarded your hard work and you continue to update/thank members who helped.
Forum: Viper Discussions - Gen I & II February 21st, 2018, 07:27 AM
Replies: 1,738
Views: 115,554
Posted By Turbokraft
^^^^^Well said, this posture (your partner)...

^^^^^Well said, this posture (your partner) represents a lot of business owners. The housing bust of recent years being a good example.
Showing results 1 to 25 of 167

 
Forum Jump


All times are GMT -5. The time now is 06:50 AM.

vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2020 DragonByte Technologies Ltd.
ViperAlley.com is in no way affiliated with Daimler Chrysler. Dodge, Viper, RT/10, the Viper logo and likeness are registered trademarks of Daimler Chrysler.
The contents of this site are owned by ViperAlley.Com and may not be used or reproduced without the express written permission of the Administrator.