Viper Alley - Dodge Viper Forum -SRT Viper - View Profile: Monto
 
Go Back   Viper Alley - Dodge Viper Forum -SRT Viper » Members List
» Live Feed « · War Room · Graffiti Wall · Arcade · Viper Blogs ·  

Monto is unremarkable with 10 points

Monto Monto is offline

n00b

Visitor Messages

Showing Visitor Messages 1 to 1 of 1
  1. viperfever1
    August 29th, 2012 02:39 PM - permalink
    viperfever1
    hey could you tell me how you did the welding connection on your viper? email me at [email protected]

About Me

  • Signature
    Heia Norge!

Statistics

Total Posts
Visitor Messages
Blog
General Information
  • Last Activity: March 5th, 2019 02:52 PM
  • Join Date: November 16th, 2009
  • Referrals: 0

Blog

View Monto's BlogRecent Entries
Latest Blog Entry

Posted February 17th, 2011 at 10:50 AM by Monto Comments 0
Posted in Uncategorized
Recently done a frame repair on an RT/10, and got it back i spec +/- one mm i tolerance.

How?
Cut out the bent parts and weld in new ones..
You will need a car o liner, or a similar jig for measurement.
And of course the measurements from the manual with date lines.

The worst part was getting off the trunkliner.
Its glued on, and i tried everything to get it off without tearing it apart. even a vibrating air knife well eneded up with...


All times are GMT -5. The time now is 12:48 PM.

vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2019 DragonByte Technologies Ltd.
ViperAlley.com is in no way affiliated with Daimler Chrysler. Dodge, Viper, RT/10, the Viper logo and likeness are registered trademarks of Daimler Chrysler.
The contents of this site are owned by ViperAlley.Com and may not be used or reproduced without the express written permission of the Administrator.