Viper Alley - Dodge Viper Forum -SRT Viper - Uncategorized
 
Go Back   Viper Alley - Dodge Viper Forum -SRT Viper » Blogs » Monto
» Live Feed « · War Room · Graffiti Wall · Arcade · Viper Blogs ·  

Uncategorized Entries with no category
Old

Frame repair, bent frame

Posted February 17th, 2011 at 10:50 AM by Monto

Recently done a frame repair on an RT/10, and got it back i spec +/- one mm i tolerance.

How?
Cut out the bent parts and weld in new ones..
You will need a car o liner, or a similar jig for measurement.
And of course the measurements from the manual with date lines.

The worst part was getting off the trunkliner.
Its glued on, and i tried everything to get it off without tearing it apart. even a vibrating air knife well eneded up with...
Attached Images
File Type: jpg folded frame 2.JPG (1.41 MB, 446 views)
File Type: jpg car o liner.JPG (119.4 KB, 450 views)
File Type: jpg rear naked.JPG (1.37 MB, 435 views)
File Type: jpg right rearwheel.JPG (1.34 MB, 378 views)
File Type: jpg P5040310.JPG (76.1 KB, 348 views)
Monto's Avatar
n00b
Posted in Uncategorized
Views 4629 Comments 0 Monto is offline


All times are GMT -5. The time now is 06:16 AM.

vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2019 DragonByte Technologies Ltd.
ViperAlley.com is in no way affiliated with Daimler Chrysler. Dodge, Viper, RT/10, the Viper logo and likeness are registered trademarks of Daimler Chrysler.
The contents of this site are owned by ViperAlley.Com and may not be used or reproduced without the express written permission of the Administrator.