Viper Alley - Dodge Viper Forum -SRT Viper - View Single Post - Cam position sensor location?
View Single Post

Old February 17th, 2010, 09:33 AM   #14
Monzsta
Mercenary Mechanic
 
Monzsta's Avatar
 
Monzsta is offline
Join Date: May 2007
Location: NC
Posts: 4,783
Blog Entries: 1
Monzsta is not afraid of bears with 17456 pointsMonzsta is not afraid of bears with 17456 pointsMonzsta is not afraid of bears with 17456 pointsMonzsta is not afraid of bears with 17456 pointsMonzsta is not afraid of bears with 17456 pointsMonzsta is not afraid of bears with 17456 pointsMonzsta is not afraid of bears with 17456 pointsMonzsta is not afraid of bears with 17456 pointsMonzsta is not afraid of bears with 17456 pointsMonzsta is not afraid of bears with 17456 pointsMonzsta is not afraid of bears with 17456 points
Rep Power: 132
Quote:
Originally Posted by Dom426h View Post
Sticking your finger in the hole is much easier and less time consuming than trying to stick something in there to measure the distance. IMO

Stick your finger in the hole lightly touching the side of the gear. have a buddy slowly turn the crank with a breakerbar (take most of the sparkplugs out to make it easier to turn) . Eventually the side of the gear will lop your finger off. (half of the gear is lower than the other half). Once you are sure the raised section is over the hole, stick the sensor in untill it contacts, then just back her out a hair before tightening.
Fixed.

The rib on the gear is sharp and at a right angle, designed specifically for personal injury. If you do it this way, be very careful. The new sensor should have a paper dot glued on the end of it. That sets the air gap. just make sure it butts against the meat cleaver rib and you're good to go.
  Reply With Quote