Please help Clutch problem

[Becustom]

I just installed a new Clutch ,pressure plate, Aluminum flywheel.
When I started the car and pushed in the clutch there was not much pedal
then I looked under it and the slave is leaking . I did not replace the slave
can any one tell me what went wrong.
Thanks

[Becustom]

Sorry I should have used the search first.

[The Former PFR]

Originally Posted by Becustom

Sorry I should have used the search first.

Does that mean you found your answer?

[Becustom]

Well not really . My car has 7500 miles on it and I don't see why I would have to put a new slave in when I replaced the clutch.
I used a trans jack and it came apart & went back together with ease.
Am just puzzled why it would be leaking now.
I could see it if I horsed it around to get it out or in, But thats not the case here.

[Monzsta]

Sure you got the disconnect fully seated?

[Becustom]

Yes , I just pulled it back out and can't find a crack or any thing wrong.
It looks like the fluid is coming out around the shaft.
Ordered a new slave. Is there anyway to bench test them ?

[Monzsta]

Nope. It might have gotten cracked, or it got overextended during install. Did you use the old trick of mashing the clutch pedal a few times to get the clutch disc to line up before having the trans fully seated to the block/bellhousing? Hydraulic clutches don't like that.

[Becustom]

Found the crack damn it was on the edge hard to see. Must have fucked it up when pulling it out.
The roe throttle body is sweet.

[Monzsta]

Don't feel bad, it's not hard to do. I've messed up my share of 'em.