Help with noise from passenger rear end on 04 SRT10

[KingSRT001]

Anyone have any experience with this (a loud clunk when moving from a dead stop, but not as loud when you rev up a little), i plan on taking it to the dealership this week....i was also told there's an open recall on the car.....thanks in advance

[ViperLover]

Open recall on the SRT 04? I'd like to know that myself.

[02 VIPER GTS]

It could be the half shaft might have to be balanced.

[SANDHU]

Anyone find out about this recall?

[KingSRT001]

I plan on taking the car in on Tuesday.....i can call my service guy tomorrow and find out what the recall is and post it here

[Becustom]

Just got my rear end back from Drive train specialist (DTS) they set up my 3.55
gears for me and they said that the center pin lock bolt was loose . Good thing I changed the gears. Not saying that it's whats wrong with yours .
Good luck.

[SoCal Rebell]

Dunno about the Gen 3 but my Gen 2 had that problem and it was the mounting bolts for the rear diff were loose, especially the 2 top bolts.

[Joelcool]

My 03 would "clunk" when I down shifted but it would only do it once. I had to put it in reverse and roll back a few feet for it to do it again. I took the local viper tech at Dodge for a ride and showed him. He put it on the lift and tightened everything in the rear suspension and the "clunk" has disappeared! This is after I switched to 3.55 gears so that could not have been it. GL

[KingSRT001]

i did drop the car off this am, the recall has to do with the Camshaft. Klunking noise will be looked into in the morning....from talking with the tech, it might be some bolts that needs tightening but he'll know more tomorrow....

[KingSRT001]

Just got my car back today, was told it was the Rear Hub Assembly, it was replaced and now drives like new.....thanks guys for the input