NEW 6060 Installed

[SixFootSix]

I had Tomball Dodge do a new 6060 in my 06. This thing feels great. Short and smooth shifts. Hopefully it last a long time. Tried not to beat on it to hard this weekend, but that was kinda hard to do on a 150 car cruise down to Galveston. The High Tech Corvette film guy was out there and he couldn't keep the camera off this car, should have some footage in about two weeks he said.

Did the conversion per this link.
https://www.viperpartsofamerica.com/...conversion-kit

Original Thread.
http://www.viperalley.com/forum/vipe...nsmission.html

[virginiavenom]

so how much overall for the upgrade?

[SixFootSix]

I bought the trans, driveshaft, and crossmember new, had yoke off of new shaft installed on my Mark Williams shaft and balanced plus the labor was about 5K.

[virginiavenom]

not too bad.

[Disturbed 01]

Originally Posted by SixFootSix

I bought the trans, driveshaft, and crossmember new, had yoke off of new shaft installed on my Mark Williams shaft and balanced plus the labor was about 5K.

So the yoke just needs to be changed on the Drive Shaft and you can re-use the old one? I hope this works for Gen 2 as well. I don't want to sell my CF Drive Shaft, I love that thing.

[Tiago]

saw some pictures of your car on the cruise, looked good!

[SixFootSix]

Originally Posted by Disturbed 01

So the yoke just needs to be changed on the Drive Shaft and you can re-use the old one? I hope this works for Gen 2 as well. I don't want to sell my CF Drive Shaft, I love that thing.

The shafts are the same length. I put them side by side when I was at the shop. If you want to just stick the new shaft and yoke in, you can, if you want to reuse your shaft, you will need to install the new yoke from the new shaft like I did.

[SixFootSix]

Originally Posted by Tiago

saw some pictures of your car on the cruise, looked good!

Thanks!
Where did you see them? link?