Wideband Guages

[SYNFULL]

I am going to install a wideband on drivers side for now. I have a pillar gauge pod that holds 2 gauges. I am thinking Boost, and Air Fuel. Anyone know or have these 2 gauges that match by the same mfgr. and look like they belong? I am thinking autometer has the largest selection - does anyone have this combination?
The Innovative XD-16 looks real nice but they are $230@

[Red Snake]

I am looking too. I currently have a boost gauge in the top hole and a combination rpm/shift light in the lower hole that looks like ass. That's coming out and a wideband is going in.

[zengarage]

i will post some pics tomorrow of a project paxton car we just finished. wideband, boost and a/f custom mounted in the glovebox.

[SYNFULL]

Originally Posted by Red Snake

I am looking too. I currently have a boost gauge in the top hole and a combination rpm/shift light in the lower hole that looks like ass. That's coming out and a wideband is going in.

What kind of boost gauge do you have? Is the right size 2 1/16? Did you go with mechanical (vacuum line) or electrical (map sensor)

Thanks
Gary

[99 RT/10]

This is my set up. I have the Edlebrock A/F and the Autometer boost gauge in place of where the Alt. gauge was.

[Red Snake]

Originally Posted by SYNFULL

What kind of boost gauge do you have? Is the right size 2 1/16? Did you go with mechanical (vacuum line) or electrical (map sensor)

Thanks
Gary

Autometer, 2 1/16 and vacuum line. These gauges were already in the car when I bought it. The meth activation light (at the top) was added when I had the w/m kit installed.

[1QKVIPER]

A.R.T. put my AEM wideband gauge in the dash (in place of the battery charging gauge). It looks factory!

[Red Snake]

Be aware also, the gauge pod on the pillar obstructs your view a little bit. Not a real big problem but it definitely took me a little bit of getting used to.

[SYNFULL]

99 RT/10
That's a nice setup but I would hate to lose an air vent with the vipers suck ass airco.
Besides I bought the pillar pod about 2 years ago and finally will get a chance to use it!


Red Snake-
Thant looks great - but I do see what your talking about as far as blocking some of your view.
Thanks

[billseast]

Wish i could put my wideband gauge in my srt

[Jack B]

Originally Posted by SYNFULL

I am going to install a wideband on drivers side for now. I have a pillar gauge pod that holds 2 gauges. I am thinking Boost, and Air Fuel. Anyone know or have these 2 gauges that match by the same mfgr. and look like they belong? I am thinking autometer has the largest selection - does anyone have this combination?
The Innovative XD-16 looks real nice but they are $230@

Just keep in mind that a wideband is useless for WOT runs unless you are logging. The Innovate XD is an attractive gauge, plus, it can set an alarm or start the log session. Couple it with the the Innovate LC1 and DL32 and it doesn't get much better. Like everyone has said, it fits perfect in place of the oem voltmeter.

If you are looking for an inexpensive route, I have an Innovate LM1 with wideband and LM3 for sale.

[v8huntr]

I"m going to install AEM serial gauage and i'll post picks soon