Whats the best way to get the lights out? Do I go through the hole in front of the front wheel? Or from the top?
While I'm at it, I want to take the fog light covers off to clean behind them. They just pop off right?
Pop out the round cover and go through the hole like you thought. To get the lens off they pop off by releasing pressure near the few tabs going into the fascia. Careful not to crack them.
I just put a set of clear marker lights on my RT/10. First, I removed the larger rubber caps in front of each front wheel. Then, I reached up through those holes to access the back of the lights using a 10mm wrench to remove the two nuts that attach each light to the bumper. I think both sides took about 20 minutes total to install. The most difficult part was reaching up to the back of the lights to reinstall the nuts.
Hmmm, my new ones have studs on them. Guess I'm drilling holes.
no holes to drill!!! do as I said. when you get the 2 nuts off the back of the factory lens the original one pops out by pressing against the studs. The new one slides in and reinstall the nuts you took off the factory lens. done!if you turn the tires out of your way it makes reaching inside the hole much easier.
Linear Mode
