The valve covers are from X-metal and the roll bar from Dave at Dave's big brakes. The roll bar is made well,tucks in nice and only weighs 39 lbs. The valve covers are very well made and even look better in person.
Valve cover info: Gary -- X-Metal Engineering.
812-453-4862 or at SuperBike Shop 812-477-1740
what et/mph is that bar good for? Bandimere is really strict up here so I need to make sure Im legal before I drop a lot of money into a roll bar.
After getting kicked out of the track,(SAR) more than once for no roll bar , they said that I could come back if I installed a 4 point bar. My car runs mid tens.
I hope you wear your helmet at all times including when driving on the street. That bar is dangerous. If you get rear ended on the street you will be brain dead as a result...if you're not already for putting that POS in your car! In addition, that bar does not even clear the top of a helmet and would not be approved for track requirements.
It clears my helmet and my head just fine. Despite DD owning one , Autoform makes a good product and if I were going to track my car more than street it I would have gone for the Autoform bar even though it weighs much more. This bar will be getting some padding that I can take on and off depending on what type of driving I do.
DD is pissed because he lost his ass in the market right after I told him that he would , he was supposed to be collecting Lambos this week...........
Last edited by viper spray : September 2nd, 2007 at 02:02 PM.
In addition, that bar does not even clear the top of a helmet and would not be approved for track requirements.
