Has anyone running a Roe SC with ported heads(high flow exhaust,rockers) come up with an optimum cam grind or are we still experimenting? I realize some don't want to share their secrets.Roe performance offers a Comp Cams grind,just wanted to get some input from the "jury"! Thanks in advance!
I Just finished This Car , It has Heads, Rockers, Headers , And a crower cam.
I'm adding Nitrous .Going to Dyno Soon......
Good Luck!,
Dave
Nice #'s... comparing dyno sheets its hard for me to justify spending thousands for heads, fuel, rockers, and cam to only pick up 75RWHP and 60 RWTQ with 4 more psi.
I'm running 8# pulley all stock heads, stock rockers, stock throttle bodies and 1.5" primary SVS headers and my car made the following #'s, its a 1999 GTS with methanol, it already has the good stock cam. Post up your dyno sheet with the spray when you get it, how big of a shot are you going to run? I'm doing nitrous propane, hope to have the dyno #'s up soon! I'll probably run a 52 nitrous on each fogger nozzle.
you can pick up a lot more than 75 with the right set-up. i picked up close to 200 rwhp after doing heads,cam, and bottom end on top of my blower without w/m.
numbers should be better, were going to re dyno when the weather cools down ,that dyno was done @ 100 degrees and a whole lot of humidity. Also learned that using a brand new belt on a ROE has a tendency to slip a little ?All this is on 93 octane with the stock cat back setup. I am installing a NY-TREX Nitrous system ,Nubers should react well!!
Linear Mode
